Karl Kurbjun 7510335fc4 This is a big chunk of code necessary to prepare for Gigabeat F flash loading and and implementation of rolo. There should be no noticible changes for the user. A new bootloader is not needed. ... git-svn-id: svn://svn.rockbox.org/rockbox/trunk@17213 a1c6a512-1295-4272-9138-f99709370657		2008-04-22 04:34:25 +00:00
..
common.c	Sansa C200 bootloader works fine, no need to be verbose anymore	2007-09-20 12:11:04 +00:00
common.h	In preparation for use with sansapatcher, change portalplayer bootloaders to read firmwares in mi4 format.	2007-03-16 14:28:00 +00:00
gigabeat-s.c	Enable program flow prediction in the system control coprocessor setup in the bootloader.	2008-04-21 21:45:58 +00:00
gigabeat.c	This is a big chunk of code necessary to prepare for Gigabeat F flash loading and and implementation of rolo. There should be no noticible changes for the user. A new bootloader is not needed.	2008-04-22 04:34:25 +00:00
iaudio_coldfire.c	Do core interrupt masking in a less general fashion and save some instructions to decrease size and speed things up a little bit. Small fix to a few places where interrupts would get enabled again where they shouldn't have been (context switching calls when disabled).	2008-03-26 01:50:41 +00:00
ipod.c	Revert... stupid svn doesn't complain when passing -m twice :(	2008-04-02 22:45:23 +00:00
iriver_h1x0.c	Do core interrupt masking in a less general fashion and save some instructions to decrease size and speed things up a little bit. Small fix to a few places where interrupts would get enabled again where they shouldn't have been (context switching calls when disabled).	2008-03-26 01:50:41 +00:00
iriver_h300.c	Do core interrupt masking in a less general fashion and save some instructions to decrease size and speed things up a little bit. Small fix to a few places where interrupts would get enabled again where they shouldn't have been (context switching calls when disabled).	2008-03-26 01:50:41 +00:00
main-e200r-installer.c	Hardware controlled backlight brightness for iPod Video and Nano, retaining the software PWM fade in/ fade out. * Backlight handling cleanup, getting rid of one layer of 'lowlevelness'. * Use atomic GPIO bit manipulation for PP502x backlight handling.	2007-11-12 18:49:53 +00:00
main-pp.c	sync with key list with mi4code and add the single mi4 key it had but this	2008-04-11 21:11:55 +00:00
Makefile	split boot.lds and move it into the target tree	2008-03-27 23:58:03 +00:00
mrobe500.c	Setup the touchpads to have two modes - stylus and button - and set them in button mode by default.	2008-04-15 10:35:11 +00:00
SOURCES	Revert "initial Meizu M6SL port"	2008-03-27 11:53:51 +00:00
telechips.c	D2: Update dual boot to use the hold switch. Update bootloader to show messages until HOLD released, keep holding POWER to show old debug screen (these modes will eventually be removed).	2008-04-08 08:01:18 +00:00
tpj1022.c	FS#6554 - Move bootloader code into a common file	2007-02-22 15:09:49 +00:00