There should be no need for any compatibility hacks since this
value was mostly used internally between the SPL and bootloader.
clk_init() was the only user in the main Rockbox binary which
accessed it, but when loaded by the Rockbox bootloader that code
will not be reached since BOOT_FLAG_CLK_INIT is already set.
Change-Id: Idd68b9834172e652b47432bfb1e00c923ea35407
What works:
- LCD: 16-bit RGB565
- all buttons, including scrollwheel
- SD Card
- Battery level and charging/not charging status
- USB
- audio
- sample rate switching
- HP / LO detect, with "safe" fixed LO volume -
LO volume will only be put to user-defined max volume
if headphones are not present.
- rtc
- Plugins build, tried a couple and they seem OK
- Bootloader, installable to nand via usbboot
What doesn't work:
- Dual Boot
- power on/off has intermittent, low volume audio click
(sometimes it's completely silent, sometimes there's
a click)
- Audio uses 16-bit volume scaling, so clicking/popping
is pretty bad at lower volumes - need 32 bit volume
scaling, 24 bit I2S data
- USB HID keys not yet defined
- no jztool support
Unknowns:
- Stereo Switch pins: Direction select, AC_DC
(probably not even hooked up)
- What is the actual purpose of the Stereo Swtich?
- How does the bluetooth module connect?
"Someday" stuff:
- get LCD working at higher bit depth
- Bluetooth
Change-Id: I70dda8fc092c6e3f4352f2245e4164193f803c33
This streamlines the boot code a bit and reduces target specific
boilerplate. The clock init hack used by the bootloader has been
"standardized" and works for the main Rockbox binary now, so you
can boot rockbox.bin over USB without special hacks.
Change-Id: I7c1fac37df5a45873583ce6818eaedb9f71a782b
