NOTE: this commit does not introduce any change, ideally even the binary should
be almost the same. I checked the disassembly by hand and there are only a few
differences here and there, mostly the compiler decides to compile very close
expressions slightly differently. I tried to run the new code on several targets
to make sure and saw no difference.
The major syntax changes of the new headers are as follows:
- BF_{WR,SET,CLR} are now superpowerful and allows to set several fileds at once:
BF_WR(reg, field1(value1), field2(value2), ...)
- BF_CS (use like BF_WR) does a write to reg_CLR and then reg_SET instead of RMW
- there is no more need for macros like BF_{WR_,SET,CLR}_V, since one can simply
BF_WR with field_V(name)
- the old BF_SETV macro has no trivial equivalent and is replaced with its
its equivalent for BF_WR(reg_SET, ...)
I also rename the register headers: "regs/regs-x.h" -> "regs/x.h" to avoid the
redundant "regs".
Final note: the registers were generated using the following command:
./headergen_v2 -g imx -o ../../firmware/target/arm/imx233/regs/ desc/regs-stmp3{600,700,780}.xml
Change-Id: I7485e8b4315a0929a8edb63e7fa1edcaa54b1edc
The lradc architecture of the stmp3600 is rather different:
only channels 6 and 7 have configurable source and we need to
take care when allocating channels so that we can actually
measure the right channel! Delegate die temperature sensing to
the power block on stmp3600.
Change-Id: I0860eb4ea98240facc3d4a19d61684eca5f630cc
Rework code to be more useful:
- move battery channel init to lradc
- always init lradc from system (previously from adc)
- don't reserve channels for vddio, nmos or pmos
- implement external temperature sensing using current source
- use this for battery sensing on the Fuze+ (calibration needed)
Change-Id: I5f9a24b9243db7d1e6bdb16b84bc891e61d0c318
