rockbox/firmware/export/sd.h
Rafaël Carré 814ffffdbe Add INIT_ATTR to storage_init() when possible
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@31036 a1c6a512-1295-4272-9138-f99709370657
2011-11-20 18:44:40 +00:00

170 lines
6.7 KiB
C

/***************************************************************************
* __________ __ ___.
* Open \______ \ ____ ____ | | _\_ |__ _______ ___
* Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ /
* Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < <
* Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \
* \/ \/ \/ \/ \/
* $Id$
*
* Copyright (C) 2002 by Alan Korr
* Copyright (C) 2008 by Frank Gevaerts
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* as published by the Free Software Foundation; either version 2
* of the License, or (at your option) any later version.
*
* This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY
* KIND, either express or implied.
*
****************************************************************************/
#ifndef __SD_H__
#define __SD_H__
#include <stdbool.h>
#include "mv.h" /* for HAVE_MULTIDRIVE or not */
#ifdef HAVE_BOOTLOADER_USB_MODE
#define SD_DRIVER_CLOSE
#endif
#define SD_BLOCK_SIZE 512 /* XXX : support other sizes ? */
struct storage_info;
void sd_enable(bool on);
void sd_spindown(int seconds);
void sd_sleep(void);
void sd_sleepnow(void);
bool sd_disk_is_active(void);
int sd_soft_reset(void);
int sd_init(void) STORAGE_INIT_ATTR;
void sd_close(void);
int sd_read_sectors(IF_MD2(int drive,) unsigned long start, int count, void* buf);
int sd_write_sectors(IF_MD2(int drive,) unsigned long start, int count, const void* buf);
void sd_spin(void);
int sd_spinup_time(void); /* ticks */
#ifdef STORAGE_GET_INFO
void sd_get_info(IF_MD2(int drive,) struct storage_info *info);
#endif
#ifdef HAVE_HOTSWAP
bool sd_removable(IF_MV_NONVOID(int drive));
bool sd_present(IF_MV_NONVOID(int drive));
#endif
long sd_last_disk_activity(void);
#ifdef CONFIG_STORAGE_MULTI
int sd_num_drives(int first_drive);
#endif
/* SD States */
#define SD_IDLE 0
#define SD_READY 1
#define SD_IDENT 2
#define SD_STBY 3
#define SD_TRAN 4
#define SD_DATA 5
#define SD_RCV 6
#define SD_PRG 7
#define SD_DIS 8
/* SD Commands */
#define SD_GO_IDLE_STATE 0
#define SD_ALL_SEND_CID 2
#define SD_SEND_RELATIVE_ADDR 3
#define SD_SET_DSR 4
#define SD_SWITCH_FUNC 6
#define SD_SET_BUS_WIDTH 6 /* acmd6 */
#define SD_SELECT_CARD 7 /* with card's rca */
#define SD_DESELECT_CARD 7 /* with rca = 0 */
#define SD_SEND_IF_COND 8
#define SD_SEND_CSD 9
#define SD_SEND_CID 10
#define SD_STOP_TRANSMISSION 12
#define SD_SEND_STATUS 13
#define SD_SD_STATUS 13 /* acmd13 */
#define SD_GO_INACTIVE_STATE 15
#define SD_SET_BLOCKLEN 16
#define SD_READ_SINGLE_BLOCK 17
#define SD_READ_MULTIPLE_BLOCK 18
#define SD_SEND_NUM_WR_BLOCKS 22 /* acmd22 */
#define SD_SET_WR_BLK_ERASE_COUNT 23 /* acmd23 */
#define SD_WRITE_BLOCK 24
#define SD_WRITE_MULTIPLE_BLOCK 25
#define SD_PROGRAM_CSD 27
#define SD_ERASE_WR_BLK_START 32
#define SD_ERASE_WR_BLK_END 33
#define SD_ERASE 38
#define SD_APP_OP_COND 41 /* acmd41 */
#define SD_LOCK_UNLOCK 42
#define SD_SET_CLR_CARD_DETECT 42 /* acmd42 */
#define SD_SEND_SCR 51 /* acmd51 */
#define SD_APP_CMD 55
/*
SD/MMC status in R1, for native mode (SPI bits are different)
Type
e : error bit
s : status bit
r : detected and set for the actual command response
x : detected and set during command execution. the host must poll
the card by sending status command in order to read these bits.
Clear condition
a : according to the card state
b : always related to the previous command. Reception of
a valid command will clear it (with a delay of one command)
c : clear by read
*/
#define SD_R1_OUT_OF_RANGE (1 << 31) /* erx, c */
#define SD_R1_ADDRESS_ERROR (1 << 30) /* erx, c */
#define SD_R1_BLOCK_LEN_ERROR (1 << 29) /* erx, c */
#define SD_R1_ERASE_SEQ_ERROR (1 << 28) /* er, c */
#define SD_R1_ERASE_PARAM (1 << 27) /* exx, c */
#define SD_R1_WP_VIOLATION (1 << 26) /* erx, c */
#define SD_R1_CARD_IS_LOCKED (1 << 25) /* sx, a */
#define SD_R1_LOCK_UNLOCK_FAILED (1 << 24) /* erx, c */
#define SD_R1_COM_CRC_ERROR (1 << 23) /* er, b */
#define SD_R1_ILLEGAL_COMMAND (1 << 22) /* er, b */
#define SD_R1_CARD_ECC_FAILED (1 << 21) /* erx, c */
#define SD_R1_CC_ERROR (1 << 20) /* erx, c */
#define SD_R1_ERROR (1 << 19) /* erx, c */
#define SD_R1_UNDERRUN (1 << 18) /* ex, c */
#define SD_R1_OVERRUN (1 << 17) /* ex, c */
#define SD_R1_CSD_OVERWRITE (1 << 16) /* erx, c */
#define SD_R1_WP_ERASE_SKIP (1 << 15) /* erx, c */
#define SD_R1_CARD_ECC_DISABLED (1 << 14) /* sx, a */
#define SD_R1_ERASE_RESET (1 << 13) /* sr, c */
#define SD_R1_STATUS(x) (x & 0xFFFFE000)
#define SD_R1_CURRENT_STATE(x) ((x & 0x00001E00) >> 9) /* sx, b (4 bits) */
#define SD_R1_READY_FOR_DATA (1 << 8) /* sx, a */
#define SD_R1_APP_CMD (1 << 5) /* sr, c */
#define SD_R1_AKE_SEQ_ERROR (1 << 3) /* er, c */
/* SD OCR bits */
#define SD_OCR_CARD_CAPACITY_STATUS (1 << 30) /* Card Capacity Status */
/* All R1 Response flags that indicate Card error(vs MCI Controller error) */
#define SD_R1_CARD_ERROR ( SD_R1_OUT_OF_RANGE \
| SD_R1_ADDRESS_ERROR \
| SD_R1_BLOCK_LEN_ERROR \
| SD_R1_ERASE_SEQ_ERROR \
| SD_R1_ERASE_PARAM \
| SD_R1_WP_VIOLATION \
| SD_R1_LOCK_UNLOCK_FAILED \
| SD_R1_COM_CRC_ERROR \
| SD_R1_ILLEGAL_COMMAND \
| SD_R1_CARD_ECC_FAILED \
| SD_R1_CC_ERROR \
| SD_R1_ERROR \
| SD_R1_UNDERRUN \
| SD_R1_CSD_OVERWRITE \
| SD_R1_WP_ERASE_SKIP \
| SD_R1_AKE_SEQ_ERROR)
#endif