..
sansa-c200v2
Sansa c200v2: enable battery charging
2010-01-17 14:19:31 +00:00
sansa-clip
Clip+: LCD display (with FlynDice help)
2010-02-17 18:43:13 +00:00
sansa-clipplus
Clip+: greylib
2010-02-22 10:35:51 +00:00
sansa-clipv2
Sansa as3525v2: move SD embryo code to a common dir
2010-01-13 06:44:45 +00:00
sansa-e200v2
Update on even pixel boundaries on the e200v2 for best performance (was forgotten in r24198).
2010-01-26 21:31:53 +00:00
sansa-fuze
Sansa AMS: Time has shown that switching between 16 and 32bit mode costs much time (due to the micro delay needed), so do 32bit transfers unconditionally for lcd updates at the cost of updating slightly larger rectangles (gives upto 15% speed up, nearly at maximum now).
2010-01-07 22:21:41 +00:00
sansa-m200v4
adc-target.h
Sansa AMS: use the AS3514 ADC driver
2008-11-10 20:55:56 +00:00
app.lds
ascodec-as3525.c
ascodec-target.h
FS#10344 - AMSSansa Dynamically adjust core voltage to extend playtime.
2009-06-30 17:56:21 +00:00
audio-as3525.c
as3525v2: build normal firmware properly (Clipv2/+)
2010-02-22 02:42:58 +00:00
backlight-e200v2-fuze.c
boot.lds
Clip+ boots with iram mapped at 0x0, only the clipv2 is different
2010-02-22 05:41:05 +00:00
button-e200v2-fuze.c
Sansa AMS: refactor DBOP button reading (e200v2/Fuze/c200v2)
2010-01-06 23:41:36 +00:00
clock-target.h
as3525v2: share more of system_init() between the 2 SoCs
2010-02-23 06:59:58 +00:00
dbop-as3525.c
Sansa AMS: Time has shown that switching between 16 and 32bit mode costs much time (due to the micro delay needed), so do 32bit transfers unconditionally for lcd updates at the cost of updating slightly larger rectangles (gives upto 15% speed up, nearly at maximum now).
2010-01-07 22:21:41 +00:00
dbop-as3525.h
Sansa AMS: Time has shown that switching between 16 and 32bit mode costs much time (due to the micro delay needed), so do 32bit transfers unconditionally for lcd updates at the cost of updating slightly larger rectangles (gives upto 15% speed up, nearly at maximum now).
2010-01-07 22:21:41 +00:00
debug-as3525.c
Sansa AMS: refactor DBOP button reading (e200v2/Fuze/c200v2)
2010-01-06 23:41:36 +00:00
debug-target.h
dma-pl081.c
Sansa AMS: VIC_INT_ENABLE register is not a mask
2009-11-24 12:05:53 +00:00
dma-target.h
Add DMA line for SSP as used in Clip+
2010-02-08 08:13:52 +00:00
fmradio-i2c-as3525.c
FS#10047 : Clipv2
2009-12-31 19:15:20 +00:00
i2s-as3525.c
Fix Clip firmware building by adding missing symbols
2008-11-10 11:04:43 +00:00
kernel-as3525.c
Sansa AMS: VIC_INT_ENABLE register is not a mask
2009-11-24 12:05:53 +00:00
lcd-as-e200v2-fuze.S
Sansa e200v2/Fuze: Optimize YUV blitting by writing 2 pixel at once to the DBOP and removing a few unneeded busy polling status register for fifo empty. Speed up between 50% and 80%.
2010-01-08 16:41:36 +00:00
pcm-as3525.c
Sansa AMS: allow use of PLL B for more accurate audio sample rate (0.04% instead 0.15% error)
2010-01-10 14:24:45 +00:00
power-as3525.c
powermgmt-as3525.c
powermgmt-target.h
Make Clip+ bootloader build
2010-02-05 12:40:25 +00:00
sd-as3525.c
Sansa AMS: remove "ata" from SD drivers filenames
2010-01-15 14:03:41 +00:00
sd-as3525v2.c
sd-as3525v2: unaligned transfers are handled properly (with memcpy)
2010-02-23 01:00:21 +00:00
system-as3525.c
as3525v2: share more of system_init() between the 2 SoCs
2010-02-23 06:59:58 +00:00
system-target.h
timer-as3525.c
Sansa AMS: VIC_INT_ENABLE register is not a mask
2009-11-24 12:05:53 +00:00
usb-as3525.c
Sansa Fuze & e200v2 : do not enable USBSTACK in the bootloader
2009-10-15 10:23:18 +00:00
usb-drv-as3525.c
Sansa AMS: VIC_INT_ENABLE register is not a mask
2009-11-24 12:05:53 +00:00
e32e180244