rockbox/firmware/target/arm/imx233/regs/stmp3700
Amaury Pouly eac1ca22bd imx233: generate register headers using headergen_v2 and update code for it
NOTE: this commit does not introduce any change, ideally even the binary should
be almost the same. I checked the disassembly by hand and there are only a few
differences here and there, mostly the compiler decides to compile very close
expressions slightly differently. I tried to run the new code on several targets
to make sure and saw no difference.

The major syntax changes of the new headers are as follows:
- BF_{WR,SET,CLR} are now superpowerful and allows to set several fileds at once:
  BF_WR(reg, field1(value1), field2(value2), ...)
- BF_CS (use like BF_WR) does a write to reg_CLR and then reg_SET instead of RMW
- there is no more need for macros like BF_{WR_,SET,CLR}_V, since one can simply
  BF_WR with field_V(name)
- the old BF_SETV macro has no trivial equivalent and is replaced with its
  its equivalent for BF_WR(reg_SET, ...)

I also rename the register headers: "regs/regs-x.h" -> "regs/x.h" to avoid the
redundant "regs".

Final note: the registers were generated using the following command:
./headergen_v2 -g imx -o ../../firmware/target/arm/imx233/regs/ desc/regs-stmp3{600,700,780}.xml

Change-Id: I7485e8b4315a0929a8edb63e7fa1edcaa54b1edc
2016-05-28 16:49:22 +02:00
..
apbh.h
apbx.h
audioin.h
audioout.h
clkctrl.h
dcp.h
digctl.h
dram.h
dri.h
ecc8.h
emi.h
gpiomon.h
gpmi.h
i2c.h
icoll.h
ir.h
lcdif.h
lradc.h
ocotp.h
pinctrl.h
power.h
pwm.h
rtc.h
saif.h
spdif.h
ssp.h
timrot.h
uartapp.h
uartdbg.h
usbctrl.h
usbphy.h