Andree Buschmann 30b29f1866 Fix or at least significantly improve FS#11830. With introduction of ATA DMA for PP502x a special treatment of the IDE0_CFG register for the iPod nano (see FS#7510) was lost. ... git-svn-id: svn://svn.rockbox.org/rockbox/trunk@29106 a1c6a512-1295-4272-9138-f99709370657		2011-01-21 23:32:57 +00:00
..
archos/av300	Rework ATA driver to get rid of lots of target-specific constants and allow for non-memory-mapped task file registers.	2011-01-02 22:51:47 +00:00
as3525	Fuze v2: Do button reading more efficiently by mapping button codes directly to the GPIO pin states where possible (all but 'home' and hold). This makes plugins incompatible; up the min version and sort things.	2011-01-20 17:11:23 +00:00
at91sam
imx31	Gigabeat S: Renovate bootloader a bit to show splash, implement verbose, shutdown on low battery, handle hold-switch-on and wait only so long for USB if a USB charger is inserted at boot instead of being connected to a host. 'Bootloader USB mode' display is just part of normal printf stream now. Move interrupt stacks into .bss area so they aren't loaded (for firmware too).	2011-01-21 07:05:51 +00:00
ipod	Fix FS#11820. Implement LCD shutdown for iPod Photo/Color and iPod nano 1G. The code was taken from FS#10034 and slightly changed to avoid white flashing when shutting off the display.	2011-01-12 07:36:02 +00:00
iriver	Convert PortalPlayer iRivers to use USB-mode enabled bootloader. The H10 5/6GB already has a pre-boot USB mode (so it's a little redundant there) but building them the same way is simpler.	2011-01-17 06:50:27 +00:00
olympus
pbell	Get the last warning for vibe 500 bootloader.	2011-01-15 09:11:38 +00:00
philips	e200v1 seems to be ok using USB-enabled bootloader. Also, include the bootloader USB .lds into the boot.lds instead of pasting into every one to keep things sane for now-- commented upon inside.	2011-01-16 01:40:15 +00:00
pnx0101
s3c2440	Rework ATA driver to get rid of lots of target-specific constants and allow for non-memory-mapped task file registers.	2011-01-02 22:51:47 +00:00
s5l8700	Remove files accidentally commited in 28953	2011-01-03 13:24:27 +00:00
s5l8702	Fix iPod Classic LCD problems	2011-01-08 21:01:06 +00:00
samsung
sandisk	Fix r29062 warning.	2011-01-16 01:48:15 +00:00
tatung
tcc77x
tcc780x	Try to get some control over #ifdef hell in usb.c by refactoring and inline function use. SYS_USB_DISCONNECTED_ACK hasn't been doing anything useful for the USB thread; remove it. USB thread simply ignores that value. Observe only valid usb_state transitions.	2011-01-18 14:10:06 +00:00
tms320dm320	Fix r29053 red and a leftover use of 'usb' variable as a bool rather than int in main-pp.c.	2011-01-15 08:52:59 +00:00
adc-as3514.c
adc-pp5020.c
ascodec-pp.c
ascodec-target.h
ata-as-arm.S
ata-nand-telechips.c
ata-pp5002.c
ata-pp5020.c	Fix or at least significantly improve FS#11830. With introduction of ATA DMA for PP502x a special treatment of the IDE0_CFG register for the iPod nano (see FS#7510) was lost.	2011-01-21 23:32:57 +00:00
ata-sd-pp.c	Try to get some control over #ifdef hell in usb.c by refactoring and inline function use. SYS_USB_DISCONNECTED_ACK hasn't been doing anything useful for the USB thread; remove it. USB thread simply ignores that value. Observe only valid usb_state transitions.	2011-01-18 14:10:06 +00:00
ata-target.h	Bootloader USB mode for PP502x. Enable only on GoGear SA9200 for the time being. Add HAVE_BOOTLOADER_USB_MODE to config if BOOTLOADER is defined to enable it. Clean up some kernel stuff a little to support it. Mess up a bunch of other stuff (hopefully not too badly).	2011-01-15 08:19:30 +00:00
audio-pp.c
bits-armv4.S
bits-armv6.S
boot-pp502x-bl-usb.lds	e200v1 seems to be ok using USB-enabled bootloader. Also, include the bootloader USB .lds into the boot.lds instead of pasting into every one to keep things sane for now-- commented upon inside.	2011-01-16 01:40:15 +00:00
crt0-pp-bl.S
crt0-pp.S
crt0-pp502x-bl-usb.S	Bootloader USB mode for PP502x. Enable only on GoGear SA9200 for the time being. Add HAVE_BOOTLOADER_USB_MODE to config if BOOTLOADER is defined to enable it. Clean up some kernel stuff a little to support it. Mess up a bunch of other stuff (hopefully not too badly).	2011-01-15 08:19:30 +00:00
crt0.S
debug-pp.c
debug-target.h
ffs-arm.S
i2c-pp.c
i2c-telechips.c
i2s-pp.c
kernel-pp.c	Bootloader USB mode for PP502x. Enable only on GoGear SA9200 for the time being. Add HAVE_BOOTLOADER_USB_MODE to config if BOOTLOADER is defined to enable it. Clean up some kernel stuff a little to support it. Mess up a bunch of other stuff (hopefully not too badly).	2011-01-15 08:19:30 +00:00
lcd-as-memframe.S
lcd-c200_c200v2.c
lcd-ssd1815.c
memcpy-arm.S
memmove-arm.S
memset-arm.S
memset16-arm.S
mmu-arm.h
mmu-arm.S	New port: iPod Classic (also known as iPod 6G/6.5G/7G)	2011-01-02 23:16:27 +00:00
mmu-armv6.S
pcm-pp.c
pcm-telechips.c
powermgmt-ascodec.c
sd-pp-target.h
support-arm.S
system-arm.c
system-arm.h
system-pp502x.c	Add a higher level USB detection that prevents fraudulent bus resets from causing USB mode to be entered. Enable for SA9200 only at this time. Also, for SA9200, use the bus power GPIO rather than the 'connector inserted' GPIO to detect the cable.	2011-01-17 12:24:41 +00:00
system-pp5002.c
system-target.h	Bootloader USB mode for PP502x. Enable only on GoGear SA9200 for the time being. Add HAVE_BOOTLOADER_USB_MODE to config if BOOTLOADER is defined to enable it. Clean up some kernel stuff a little to support it. Mess up a bunch of other stuff (hopefully not too badly).	2011-01-15 08:19:30 +00:00
thread-arm.c	New port: iPod Classic (also known as iPod 6G/6.5G/7G)	2011-01-02 23:16:27 +00:00
thread-pp.c
timer-pp.c
usb-drv-arc.c	Add a higher level USB detection that prevents fraudulent bus resets from causing USB mode to be entered. Enable for SA9200 only at this time. Also, for SA9200, use the bus power GPIO rather than the 'connector inserted' GPIO to detect the cable.	2011-01-17 12:24:41 +00:00
usb-fw-pp502x.c	PP502x USB: It seems r29087 introduced additional parasitic current consumption after USB disconnect. So, reinitialize the controller just like at startup when disabling USB, which also happens to fix FS#10719.	2011-01-20 06:41:05 +00:00
usb-fw-pp5002.c	Fix r29053 red and a leftover use of 'usb' variable as a bool rather than int in main-pp.c.	2011-01-15 08:52:59 +00:00
usb-s3c6400x.c	Fix yellow, already assign values for various S5L8702 defines	2010-12-12 00:59:59 +00:00
usb-target.h	Bootloader USB mode for PP502x. Enable only on GoGear SA9200 for the time being. Add HAVE_BOOTLOADER_USB_MODE to config if BOOTLOADER is defined to enable it. Clean up some kernel stuff a little to support it. Mess up a bunch of other stuff (hopefully not too badly).	2011-01-15 08:19:30 +00:00
usb-tcc.c
wmcodec-pp.c
wmcodec-telechips.c