Jack Halpin 241abf4bc5 sd-as3525v2.c: Correct some #defines, add comments, attempt to lower sd frequency to 400 khz during init. ... I've left in some commented out code for now as this is still a bit experimental..... git-svn-id: svn://svn.rockbox.org/rockbox/trunk@24891 a1c6a512-1295-4272-9138-f99709370657		2010-02-24 20:24:48 +00:00
..
sansa-c200v2	Sansa c200v2: enable battery charging	2010-01-17 14:19:31 +00:00
sansa-clip	Clip+: LCD display (with FlynDice help)	2010-02-17 18:43:13 +00:00
sansa-clipplus	Clip+: greylib	2010-02-22 10:35:51 +00:00
sansa-clipv2	Sansa as3525v2: move SD embryo code to a common dir	2010-01-13 06:44:45 +00:00
sansa-e200v2	Update on even pixel boundaries on the e200v2 for best performance (was forgotten in r24198).	2010-01-26 21:31:53 +00:00
sansa-fuze	Sansa AMS: Time has shown that switching between 16 and 32bit mode costs much time (due to the micro delay needed), so do 32bit transfers unconditionally for lcd updates at the cost of updating slightly larger rectangles (gives upto 15% speed up, nearly at maximum now).	2010-01-07 22:21:41 +00:00
sansa-m200v4
adc-target.h
app.lds
ascodec-as3525.c	Sansa AMS : don't use the SHAREDBSS_ATTR since we don't have a coprocessor	2009-06-02 22:45:02 +00:00
ascodec-target.h
audio-as3525.c	as3525v2: build normal firmware properly (Clipv2/+)	2010-02-22 02:42:58 +00:00
backlight-e200v2-fuze.c
boot.lds	Clip+ boots with iram mapped at 0x0, only the clipv2 is different	2010-02-22 05:41:05 +00:00
button-e200v2-fuze.c
clock-target.h	as3525v2: share more of system_init() between the 2 SoCs	2010-02-23 06:59:58 +00:00
dbop-as3525.c	Sansa AMS: Time has shown that switching between 16 and 32bit mode costs much time (due to the micro delay needed), so do 32bit transfers unconditionally for lcd updates at the cost of updating slightly larger rectangles (gives upto 15% speed up, nearly at maximum now).	2010-01-07 22:21:41 +00:00
dbop-as3525.h	Sansa AMS: Time has shown that switching between 16 and 32bit mode costs much time (due to the micro delay needed), so do 32bit transfers unconditionally for lcd updates at the cost of updating slightly larger rectangles (gives upto 15% speed up, nearly at maximum now).	2010-01-07 22:21:41 +00:00
debug-as3525.c
debug-target.h
dma-pl081.c
dma-target.h	Add DMA line for SSP as used in Clip+	2010-02-08 08:13:52 +00:00
fmradio-i2c-as3525.c
i2s-as3525.c
kernel-as3525.c
lcd-as-e200v2-fuze.S	Sansa e200v2/Fuze: Optimize YUV blitting by writing 2 pixel at once to the DBOP and removing a few unneeded busy polling status register for fifo empty. Speed up between 50% and 80%.	2010-01-08 16:41:36 +00:00
pcm-as3525.c	Sansa AMS: allow use of PLL B for more accurate audio sample rate (0.04% instead 0.15% error)	2010-01-10 14:24:45 +00:00
power-as3525.c	Make si4700 tuner driver more sane with bit and field defines and entirely hide strange i2c interface from code with write/set/clear/masked functionality. On Gigabeat S use by-the-book busmode selection and GPIO lines. Implement some primitive station detection, debug registers in screen, and misc. changes to tie things together.	2008-12-27 19:18:50 +00:00
powermgmt-as3525.c
powermgmt-target.h	Make Clip+ bootloader build	2010-02-05 12:40:25 +00:00
sd-as3525.c	Sansa AMS: remove "ata" from SD drivers filenames	2010-01-15 14:03:41 +00:00
sd-as3525v2.c	sd-as3525v2.c: Correct some #defines, add comments, attempt to lower sd frequency to 400 khz during init.	2010-02-24 20:24:48 +00:00
system-as3525.c	as3525v2: share more of system_init() between the 2 SoCs	2010-02-23 06:59:58 +00:00
system-target.h
timer-as3525.c
usb-as3525.c
usb-drv-as3525.c