rockbox/firmware/target/arm/imx31/ccm-imx31.h

124 lines
3 KiB
C

/***************************************************************************
* __________ __ ___.
* Open \______ \ ____ ____ | | _\_ |__ _______ ___
* Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ /
* Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < <
* Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \
* \/ \/ \/ \/ \/
* $Id$
*
* Copyright (c) 2008 Michael Sevakis
*
* Clock control functions for IMX31 processor
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License
* as published by the Free Software Foundation; either version 2
* of the License, or (at your option) any later version.
*
* This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY
* KIND, either express or implied.
*
****************************************************************************/
#ifndef _CCM_IMX31_H_
#define _CCM_IMX31_H_
enum IMX31_CG_LIST
{
/* CGR0 */
CG_SD_MMC1 = 0,
CG_SD_MMC2,
CG_GPT,
CG_EPIT1,
CG_EPIT2,
CG_IIM,
CG_ATA,
CG_SDMA,
CG_CSPI3,
CG_RNG,
CG_UART1,
CG_UART2,
CG_SSI1,
CG_I2C1,
CG_I2C2,
CG_I2C3,
/* CGR1 */
CG_HANTRO,
CG_MEMSTICK1,
CG_MEMSTICK2,
CG_CSI,
CG_RTC,
CG_WDOG,
CG_PWM,
CG_SIM,
CG_ECT,
CG_USBOTG,
CG_KPP,
CG_IPU,
CG_UART3,
CG_UART4,
CG_UART5,
CG_1_WIRE,
/* CGR2 */
CG_SSI2,
CG_CSPI1,
CG_CSPI2,
CG_GACC,
CG_EMI,
CG_RTIC,
CG_FIR,
CG_NUM_CLOCKS
};
enum IMX31_CG_MODES
{
CGM_OFF = 0x0, /* Always off */
CGM_ON_RUN = 0x1, /* On in run mode, off in wait and doze */
CGM_ON_RUN_WAIT = 0x2, /* On in run and wait modes, off in doze */
CGM_ON_ALL = 0x3, /* Always on */
};
#define CG_MASK 0x3 /* bitmask */
/* Enable or disable module clocks independently - module must _not_ be
* active! */
void ccm_module_clock_gating(enum IMX31_CG_LIST cg,
enum IMX31_CG_MODES mode);
enum IMX31_PLLS
{
PLL_MCU = 0,
PLL_USB,
PLL_SERIAL,
NUM_PLLS,
};
/* Return the current source pll for MCU */
enum IMX31_PLLS ccm_get_src_pll(void);
/* Decode PLL output frequency from register value */
unsigned int ccm_calc_pll_rate(unsigned int infreq, unsigned long regval);
/* Get the PLL reference clock frequency in HZ */
unsigned int ccm_get_pll_ref_clk_rate(void);
/* Return PLL frequency in HZ */
unsigned int ccm_get_pll_rate(enum IMX31_PLLS pll);
/* Return MCU frequency in HZ */
unsigned int ccm_get_mcu_clk(void);
/* Return ipg_clk in HZ */
unsigned int ccm_get_ipg_clk(void);
/* Return ahb_clk in HZ */
unsigned int ccm_get_ahb_clk(void);
/* Return the ATA frequency in HZ */
unsigned int ccm_get_ata_clk(void);
/* Write new values to the current PLL and post-dividers */
void ccm_set_mcupll_and_pdr(unsigned long pllctl, unsigned long pdr);
#endif /* _CCM_IMX31_H_ */