Commit graph

6 commits

Author SHA1 Message Date
Michael Sevakis
bcc0f88372 Convert PortalPlayer iRivers to use USB-mode enabled bootloader. The H10 5/6GB already has a pre-boot USB mode (so it's a little redundant there) but building them the same way is simpler.
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@29067 a1c6a512-1295-4272-9138-f99709370657
2011-01-17 06:50:27 +00:00
Rafaël Carré
7d4414ebd8 AB_REPEAT_ENABLE was never defined to 2
There's only 2 possibilities: defined or undefined

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@27483 a1c6a512-1295-4272-9138-f99709370657
2010-07-18 18:13:53 +00:00
Torne Wuff
bad4142ce2 Add LBA48 support to all targets with ATA, except archoses whose USB bridge chip can't handle it.
The cost of LBA48 support is very small and it means that upgraded drives/CF cards which are over 128GiB will just work with no custom build required. There should be no runtime effect on disks which do not require it.


git-svn-id: svn://svn.rockbox.org/rockbox/trunk@25553 a1c6a512-1295-4272-9138-f99709370657
2010-04-09 12:10:17 +00:00
Jeffrey Goode
d5e6bc7a8c FS#11081 - Hotkey patch. Many targets supported, but some keymaps need work before they can be switched on
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@25414 a1c6a512-1295-4272-9138-f99709370657
2010-04-01 03:14:44 +00:00
Torne Wuff
533cf7737b Enable ATA DMA on pp5020 based players with ATA drives.
DMA is only used for reading because writing seems to be slower with DMA.
Only requests which are cacheline aligned (16 bytes) will use DMA, so many
requests will still use PIO at this point; a later change will align more
reads.

Part of FS#9708, original DMA code by Boris Gjenero (dreamlayers).


git-svn-id: svn://svn.rockbox.org/rockbox/trunk@24405 a1c6a512-1295-4272-9138-f99709370657
2010-01-31 11:07:29 +00:00
Björn Stenberg
c0740440ac Rename targets to be consistent in all places. (FS #10819). Take 2.
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@23883 a1c6a512-1295-4272-9138-f99709370657
2009-12-07 12:19:08 +00:00
Renamed from firmware/export/config-h10.h (Browse further)