On STMP3700 there is no dedicated speaker amplifier but speaker is always on
lineout so it makes sense to report volume and power down of lineout.
Change-Id: If666bccf36d3a5ecc6d892823522d023f3206184
For some reason, there was a mismatch between the setting (decibel) and the
audiohw code (centicel). This resulted in a gain divided by 10. This may
explain why some people experienced low volume with the mic on the fuze+.
Change-Id: I138ac18dd93c36f43a7dfce735efc826405c598c
NOTE: this commit does not introduce any change, ideally even the binary should
be almost the same. I checked the disassembly by hand and there are only a few
differences here and there, mostly the compiler decides to compile very close
expressions slightly differently. I tried to run the new code on several targets
to make sure and saw no difference.
The major syntax changes of the new headers are as follows:
- BF_{WR,SET,CLR} are now superpowerful and allows to set several fileds at once:
BF_WR(reg, field1(value1), field2(value2), ...)
- BF_CS (use like BF_WR) does a write to reg_CLR and then reg_SET instead of RMW
- there is no more need for macros like BF_{WR_,SET,CLR}_V, since one can simply
BF_WR with field_V(name)
- the old BF_SETV macro has no trivial equivalent and is replaced with its
its equivalent for BF_WR(reg_SET, ...)
I also rename the register headers: "regs/regs-x.h" -> "regs/x.h" to avoid the
redundant "regs".
Final note: the registers were generated using the following command:
./headergen_v2 -g imx -o ../../firmware/target/arm/imx233/regs/ desc/regs-stmp3{600,700,780}.xml
Change-Id: I7485e8b4315a0929a8edb63e7fa1edcaa54b1edc
On some OSes like Windows or if running in a virtual machine, the one second
timeout might be too short.
Change-Id: I717f7a2aaed1cb3d40e8fbe6f9b1081b43ceea95
The clkctrl functions were becoming a mess. Normalise the names,
get rid of the xtal derived as special case and use the same
interface.
Change-Id: Ib954a8d30a6bd691914b5e0d97774ec9fc560c50
The headphone volume register value reads differently in Line1 and DAC mode.
Since the volume is not set again when switching between playback and radio,
we need to remember the hp volume and reapply setting when changing the mode.
Change-Id: I8fbd344f78653c19d81a39dd3f680ec6885cb1ec
