If we come up and the RTC is in a reset state, we need to release that
before trying to initialze anything else. (See IMX23RM 23.8.1 and 39.3.10)
Change-Id: I1820ab771ba81f7d428d07040b7d188d9f688127
NOTE: this commit does not introduce any change, ideally even the binary should
be almost the same. I checked the disassembly by hand and there are only a few
differences here and there, mostly the compiler decides to compile very close
expressions slightly differently. I tried to run the new code on several targets
to make sure and saw no difference.
The major syntax changes of the new headers are as follows:
- BF_{WR,SET,CLR} are now superpowerful and allows to set several fileds at once:
BF_WR(reg, field1(value1), field2(value2), ...)
- BF_CS (use like BF_WR) does a write to reg_CLR and then reg_SET instead of RMW
- there is no more need for macros like BF_{WR_,SET,CLR}_V, since one can simply
BF_WR with field_V(name)
- the old BF_SETV macro has no trivial equivalent and is replaced with its
its equivalent for BF_WR(reg_SET, ...)
I also rename the register headers: "regs/regs-x.h" -> "regs/x.h" to avoid the
redundant "regs".
Final note: the registers were generated using the following command:
./headergen_v2 -g imx -o ../../firmware/target/arm/imx233/regs/ desc/regs-stmp3{600,700,780}.xml
Change-Id: I7485e8b4315a0929a8edb63e7fa1edcaa54b1edc
This adds the application part of alarm wake up. On some targets
like the Fuze+, it will also require a bootloader change to make
sure that the device doesn't power down on alarm wake up (for
example on the Fuze+ the bootloader requires the power button to
be hold sufficiently long, thus preventing alarm wake up to work)
Change-Id: I5d01957852355fddbd48110d3d75a5533f07879e
