The current code was spreaded over power and powermgmt which made
it behave strangely, especially since there are relationships
between power management and frequency scaling. The new code makes
sure power management is initialised before frequency scaling
starts. It also makes sure to start from a known state, thus
fixing potential issue when the bootloader stops in a trickle
state where DCDC is improperly configured.
Change-Id: Ibded2e590e108f6c98daa52d2cf1bd28763c8923
There are many small differences between them. In particular
some regulators are not available on stmp3600. Also the vbusvalid
detect method is not available as an irq on stmp3600 and seems
broken on stmp3700. Finally die temperature is handled by the
power block on stmp3600.
Change-Id: I2c68b418738f15564e445d3a1496018cef97fff7
The current pinctrl functions were a mess. Normalise the functions
names to make them shorter and clearer.
Change-Id: Iac6ff84625ef2b7610268e3a5802dc0088de3167
Do low level power init in system_init(). This can be needed
since imx233 must be able to frequecy scale atfer system_init()
and kernel_init() and this is only possible if power system was
initialised.
Change-Id: I27c66ec0dccd60bda26a45be24683c0bfe72c6da
Make sure DCDC is running at boot (it is disabled by default when
5V is present and we don't want to rely on the bootloader to
change this).
When changing the voltage on a regulator, it usually takes 2ms for
the voltage to stabilize. In DCDC mode, there is an irq to notify
about the event so use it ! This is especially important when
changing cpu frequency because increasing the cpu freq while the
voltage is rising is unreliable.
Change-Id: Icfe9ef3ee90156d1e17da0820d9041859f7f3bca
Remove the old debug stuff about VDDx and add a clean api to
get/set the regulator (VDDD, VDDA, VDDIO, VDDMEM). This is useful
for proper frequency scaling.
Change-Id: Ia5a1a712fd66652a8ad9601ed00db31aba5a7561
The icoll code now has an IRQ storm detection mechanism which
will prevent the device from hard freezing in case it happen.
Change-Id: I9861238dce61d29af1e48f9c534ec63a7f23465c
Past development has proved that one can mistakely use
the same pin for two uses without noticing. Since this
causes extremely hard to find bugs, the infrastructure
will allow to register pin uses and panic when a conflict
is detected. The pinctrl debug now shows the pin uses
when its support is compiled in.
Change-Id: Idb2d5235ce09207d77aa474d6f158e72b933761a
Only enable fmradio_i2c once with _init() called from system.
Move actual i2c init to system for consistency.
Move tuner power pin setup to power instead of fmradio.
Change-Id: Idb56bfba5803f71b5d049f174c48d2afb969a6ea
- now identity map dram uncached and have a cached and buffered virtual alias
- rework dma to handle virtual to physical pointers conversion
- fix lcd frame pointer
- implement usb detection properly
- implement bootloader usb properly
- allow the bootloader to disable MMC windowing (useful for recovery)
git-svn-id: svn://svn.rockbox.org/rockbox/trunk@30432 a1c6a512-1295-4272-9138-f99709370657
