Correct beast manual install instructions in Windows.

git-svn-id: svn://svn.rockbox.org/rockbox/trunk@23467 a1c6a512-1295-4272-9138-f99709370657
This commit is contained in:
Alex Parker 2009-11-01 17:29:13 +00:00
parent 04f84cf1e8
commit b2ee0ce09f

View file

@ -40,8 +40,7 @@ information displayed about
your \dap{} and a message asking you if you wish to install the Rockbox
bootloader. Press i followed by ENTER, and beastpatcher will
install the bootloader. After a short time you should see the message
``[INFO] Bootloader installed successfully'' followed by some error
messages that you can safely ignore. Press ENTER again to exit
``[INFO] Bootloader installed successfully''. Press ENTER again to exit
beastpatcher.
\item[Dual Boot.] Extract the \playerman{} firmware file \fname{nk.bin} from
@ -54,15 +53,13 @@ to this directory, and then type the following commands:
\end{code}
After a short time you should see the message
``[INFO] Bootloader installed successfully'' followed by some error
messages that you can safely ignore. Press ENTER again to exit
``[INFO] Bootloader installed successfully''. Press ENTER again to exit
beastpatcher.
\item After a successful installation, your \dap{} will immediately turn off.
Turn it on again, and (because it is still connected to your PC)
it will enter the Rockbox bootloader's
``USB Mass Storage'' mode, which exposes your \daps{} disk to your computer
as a standard USB Mass Storage device.
\item After a successful installation, you need to disconnect your \dap{} from
USB, and then immediately reconnect it. It should reboot then enter the Rockbox
bootloader ``USB Mass Storage'' mode, which exposes your \daps{} disk to your
computer as a standard USB Mass Storage device.
\end{enumerate}
\subsubsection{Bootloader installation from Mac OS X}