rockbox/firmware/drivers/audio/wm8751.c

/***************************************************************************
 *             __________               __   ___.
 *   Open      \______   \ ____   ____ |  | _\_ |__   _______  ___
 *   Source     |       _//  _ \_/ ___\|  |/ /| __ \ /  _ \  \/  /
 *   Jukebox    |    |   (  <_> )  \___|    < | \_\ (  <_> > <  <
 *   Firmware   |____|_  /\____/ \___  >__|_ \|___  /\____/__/\_ \
 *                     \/            \/     \/    \/            \/
 * $Id$
 *
 * Driver for WM8751 audio codec
 *
 * Based on code from the ipodlinux project - http://ipodlinux.org/
 * Adapted for Rockbox in December 2005
 *
 * Original file: linux/arch/armnommu/mach-ipod/audio.c
 *
 * Copyright (c) 2003-2005 Bernard Leach (leachbj@bouncycastle.org)
 *
 * This program is free software; you can redistribute it and/or
 * modify it under the terms of the GNU General Public License
 * as published by the Free Software Foundation; either version 2
 * of the License, or (at your option) any later version.
 *
 * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY
 * KIND, either express or implied.
 *
 ****************************************************************************/
#include "kernel.h"
#include "wmcodec.h"
#include "i2s.h"
#include "audio.h"
#include "audiohw.h"
#include "system.h"

const struct sound_settings_info audiohw_settings[] = {
    [SOUND_VOLUME]        = {"dB", 0,  1, -74,   6, -25},
#ifdef USE_ADAPTIVE_BASS
    [SOUND_BASS]          = {"",   0,  1,   0,  15,   0},
#else
    [SOUND_BASS]          = {"dB", 1, 15, -60,  90,   0},
#endif
    [SOUND_TREBLE]        = {"dB", 1, 15, -60,  90,   0},
    [SOUND_BALANCE]       = {"%",  0,  1,-100, 100,   0},
    [SOUND_CHANNELS]      = {"",   0,  1,   0,   5,   0},
    [SOUND_STEREO_WIDTH]  = {"%",  0,  5,   0, 250, 100},
};

/* Flags used in combination with settings */

/* use zero crossing to reduce clicks during volume changes */
#define LOUT1_BITS      (LOUT1_LO1ZC)
/* latch left volume first then update left+right together */
#define ROUT1_BITS      (ROUT1_RO1ZC | ROUT1_RO1VU)
#define LOUT2_BITS      (LOUT2_LO2ZC)
#define ROUT2_BITS      (ROUT2_RO2ZC | ROUT2_RO2VU)
/* We use linear bass control with 200 Hz cutoff */
#ifdef USE_ADAPTIVE_BASE
#define BASSCTRL_BITS   (BASSCTRL_BC | BASSCTRL_BB)
#else
#define BASSCTRL_BITS   (BASSCTRL_BC)
#endif
/* We use linear treble control with 4 kHz cutoff */
#define TREBCTRL_BITS   (TREBCTRL_TC)

/* convert tenth of dB volume (-730..60) to master volume register value */
int tenthdb2master(int db)
{
    /* +6 to -73dB 1dB steps (plus mute == 80levels) 7bits */
    /* 1111111 ==  +6dB  (0x7f)                            */
    /* 1111001 ==   0dB  (0x79)                            */
    /* 0110000 == -73dB  (0x30)                            */
    /* 0101111..0000000 == mute  (<= 0x2f)                 */
    if (db < VOLUME_MIN)
        return 0x0;
    else
        return (db / 10) + 73 + 0x30;
}

static int tone_tenthdb2hw(int value)
{
    /* -6.0db..+0db..+9.0db step 1.5db - translate -60..+0..+90 step 15
        to 10..6..0 step -1.
    */
    value = 10 - (value + 60) / 15;

    if (value == 6)
        value = 0xf; /* 0db -> off */

    return value;
}


#ifdef USE_ADAPTIVE_BASS
static int adaptivebass2hw(int value)
{
    /* 0 to 15 step 1 - step -1  0 = off is a 15 in the register */
    value = 15 - value;

    return value;
}
#endif

/* Reset and power up the WM8751 */
void audiohw_preinit(void)
{
#ifdef MROBE_100
    /* controls headphone ouput */
    GPIOL_ENABLE     |= 0x10;
    GPIOL_OUTPUT_EN  |= 0x10;
    GPIOL_OUTPUT_VAL |= 0x10; /* disable */
#endif

#ifdef CPU_PP502x
    i2s_reset();
#endif

    /*
     * 1. Switch on power supplies.
     *    By default the WM8751 is in Standby Mode, the DAC is
     *    digitally muted and the Audio Interface, Line outputs
     *    and Headphone outputs are all OFF (DACMU = 1 Power
     *    Management registers 1 and 2 are all zeros).
     */
    wmcodec_write(RESET, RESET_RESET);    /*Reset*/

     /* 2. Enable Vmid and VREF. */
    wmcodec_write(PWRMGMT1, PWRMGMT1_VREF | PWRMGMT1_VMIDSEL_5K);

    /* BCLKINV=0(Dont invert BCLK) MS=1(Enable Master) LRSWAP=0 LRP=0 */
    /* IWL=00(16 bit) FORMAT=10(I2S format) */
    wmcodec_write(AINTFCE, AINTFCE_MS | AINTFCE_WL_16 |
                  AINTFCE_FORMAT_I2S);
}

/* Enable DACs and audio output after a short delay */
void audiohw_postinit(void)
{
    /* From app notes: allow Vref to stabilize to reduce clicks */
    sleep(HZ);

     /* 3. Enable DACs as required. */
    wmcodec_write(PWRMGMT2, PWRMGMT2_DACL | PWRMGMT2_DACR);

     /* 4. Enable line and / or headphone output buffers as required. */
#ifdef MROBE_100
    wmcodec_write(PWRMGMT2, PWRMGMT2_DACL | PWRMGMT2_DACR |
                  PWRMGMT2_LOUT1 | PWRMGMT2_ROUT1);
#else
    wmcodec_write(PWRMGMT2, PWRMGMT2_DACL | PWRMGMT2_DACR |
                  PWRMGMT2_LOUT1 | PWRMGMT2_ROUT1 | PWRMGMT2_LOUT2 |
                  PWRMGMT2_ROUT2);
#endif

    wmcodec_write(ADDITIONAL1, ADDITIONAL1_TSDEN | ADDITIONAL1_TOEN |
                    ADDITIONAL1_DMONOMIX_LLRR | ADDITIONAL1_VSEL_DEFAULT);

    wmcodec_write(LEFTMIX1, LEFTMIX1_LD2LO | LEFTMIX1_LI2LO_DEFAULT);
    wmcodec_write(RIGHTMIX2, RIGHTMIX2_RD2RO | RIGHTMIX2_RI2RO_DEFAULT);

    audiohw_mute(false);

#ifdef MROBE_100
    /* enable headphone output */
    GPIOL_OUTPUT_VAL &= ~0x10;
    GPIOL_OUTPUT_EN  |=  0x10;
#endif
}

void audiohw_set_master_vol(int vol_l, int vol_r)
{
    /* +6 to -73dB 1dB steps (plus mute == 80levels) 7bits */
    /* 1111111 ==  +6dB                                    */
    /* 1111001 ==   0dB                                    */
    /* 0110000 == -73dB                                    */
    /* 0101111 == mute (0x2f)                              */

    wmcodec_write(LOUT1, LOUT1_BITS | LOUT1_LOUT1VOL(vol_l));
    wmcodec_write(ROUT1, ROUT1_BITS | ROUT1_ROUT1VOL(vol_r));
}

#ifndef MROBE_100
void audiohw_set_lineout_vol(int vol_l, int vol_r)
{
    wmcodec_write(LOUT2, LOUT2_BITS | LOUT2_LOUT2VOL(vol_l));
    wmcodec_write(ROUT2, ROUT2_BITS | ROUT2_ROUT2VOL(vol_r));
}
#endif

void audiohw_set_bass(int value)
{
    wmcodec_write(BASSCTRL, BASSCTRL_BITS |

#ifdef USE_ADAPTIVE_BASS
        BASSCTRL_BASS(adaptivebass2hw(value)));
#else
        BASSCTRL_BASS(tone_tenthdb2hw(value)));
#endif
}

void audiohw_set_treble(int value)
{
    wmcodec_write(TREBCTRL, TREBCTRL_BITS |
        TREBCTRL_TREB(tone_tenthdb2hw(value)));
}

void audiohw_mute(bool mute)
{
    /* Mute:   Set DACMU = 1 to soft-mute the audio DACs. */
    /* Unmute: Set DACMU = 0 to soft-un-mute the audio DACs. */
    wmcodec_write(DACCTRL, mute ? DACCTRL_DACMU : 0);
}

/* Nice shutdown of WM8751 codec */
void audiohw_close(void)
{
    /* 1. Set DACMU = 1 to soft-mute the audio DACs. */
    audiohw_mute(true);

    /* 2. Disable all output buffers. */
    wmcodec_write(PWRMGMT2, 0x0);

    /* 3. Switch off the power supplies. */
    wmcodec_write(PWRMGMT1, 0x0);
}

/* Note: Disable output before calling this function */
void audiohw_set_frequency(int fsel)
{
    wmcodec_write(CLOCKING, fsel);
}