/*************************************************************************** * __________ __ ___. * Open \______ \ ____ ____ | | _\_ |__ _______ ___ * Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / * Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < * Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ * \/ \/ \/ \/ \/ * $Id$ * * Copyright © 2009 Bertrik Sikken * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version 2 * of the License, or (at your option) any later version. * * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY * KIND, either express or implied. * ****************************************************************************/ #include #include "config.h" #include "system.h" #include "audio.h" #include "s5l8700.h" #include "panic.h" #include "audiohw.h" #include "pcm.h" #include "pcm-internal.h" #include "pcm_sampr.h" #include "dma-target.h" #include "mmu-arm.h" /* Driver for the IIS/PCM part of the s5l8700 using DMA Notes: - pcm_play_dma_stop is untested, not sure if implemented the right way - recording is not implemented */ static volatile int locked = 0; static const int zerosample = 0; static unsigned char dblbuf[1024] IBSS_ATTR; static const void* queuedbuf; static size_t queuedsize; static const void* nextbuf; static size_t nextsize; static const struct div_entry { int pdiv, mdiv, sdiv, cdiv; } div_table[HW_NUM_FREQ] = { #ifdef IPOD_NANO2G [HW_FREQ_11] = { 0, 41, 3, 8}, [HW_FREQ_22] = { 0, 41, 3, 4}, [HW_FREQ_44] = { 0, 41, 3, 2}, [HW_FREQ_88] = { 0, 41, 3, 1}, [HW_FREQ_8 ] = { 0, 2, 1, 9}, [HW_FREQ_16] = { 0, 2, 0, 9}, [HW_FREQ_32] = { 2, 2, 0, 9}, [HW_FREQ_64] = { 6, 2, 0, 9}, [HW_FREQ_12] = { 0, 2, 2, 3}, [HW_FREQ_24] = { 0, 2, 1, 3}, [HW_FREQ_48] = { 0, 2, 0, 3}, [HW_FREQ_96] = { 2, 2, 0, 3}, #else /* table of recommended PLL/MCLK dividers for mode 256Fs from the datasheet */ [HW_FREQ_11] = { 26, 189, 3, 8}, [HW_FREQ_22] = { 50, 98, 2, 8}, [HW_FREQ_44] = { 37, 151, 1, 9}, [HW_FREQ_88] = { 50, 98, 1, 4}, #if 0 /* disabled because the codec driver does not support it (yet) */ [HW_FREQ_8 ] = { 28, 192, 3, 12}, [HW_FREQ_16] = { 28, 192, 3, 6}, [HW_FREQ_32] = { 28, 192, 2, 6}, [HW_FREQ_12] = { 28, 192, 3, 8}, [HW_FREQ_24] = { 28, 192, 2, 8}, [HW_FREQ_48] = { 28, 192, 2, 4}, [HW_FREQ_96] = { 28, 192, 1, 4}, #endif #endif }; /* Mask the DMA interrupt */ void pcm_play_lock(void) { if (locked++ == 0) { INTMSK &= ~(1 << 10); } } /* Unmask the DMA interrupt if enabled */ void pcm_play_unlock(void) { if (--locked == 0) { INTMSK |= (1 << 10); } } void INT_DMA(void) ICODE_ATTR; void INT_DMA(void) { bool new_buffer = false; DMACOM0 = 7; while (!(DMACON0 & (1 << 18))) { if (queuedsize) { memcpy(dblbuf, queuedbuf, queuedsize); DMABASE0 = (unsigned int)dblbuf; DMATCNT0 = queuedsize / 2 - 1; queuedsize = 0; } else { if (!nextsize) { new_buffer = pcm_play_dma_complete_callback( PCM_DMAST_OK, &nextbuf, &nextsize); if (!new_buffer) break; } queuedsize = MIN(sizeof(dblbuf), nextsize / 2); nextsize -= queuedsize; queuedbuf = nextbuf + nextsize; DMABASE0 = (unsigned int)nextbuf; DMATCNT0 = nextsize / 2 - 1; nextsize = 0; } commit_dcache(); DMACOM0 = 4; DMACOM0 = 7; if (new_buffer) { pcm_play_dma_status_callback(PCM_DMAST_STARTED); new_buffer = false; } } } void pcm_play_dma_start(const void* addr, size_t size) { /* DMA channel on */ nextbuf = addr; nextsize = size; queuedsize = 0; DMABASE0 = (unsigned int)(&zerosample); DMATCNT0 = 0; DMACOM0 = 4; /* IIS Tx clock on */ I2SCLKCON = (1 << 0); /* 1 = power on */ /* IIS Tx on */ I2STXCOM = (1 << 3) | /* 1 = transmit mode on */ (1 << 2) | /* 1 = I2S interface enable */ (1 << 1) | /* 1 = DMA request enable */ (0 << 0); /* 0 = LRCK on */ } void pcm_play_dma_stop(void) { /* DMA channel off */ DMACOM0 = 5; /* IIS Tx off */ I2STXCOM = (1 << 3) | /* 1 = transmit mode on */ (0 << 2) | /* 1 = I2S interface enable */ (1 << 1) | /* 1 = DMA request enable */ (0 << 0); /* 0 = LRCK on */ } static void pcm_dma_set_freq(enum hw_freq_indexes idx) { struct div_entry div = div_table[idx]; /* configure PLL1 and MCLK for the desired sample rate */ PLL1PMS = (div.pdiv << 16) | (div.mdiv << 8) | (div.sdiv << 0); PLL1LCNT = 280; /* 150 microseconds */ /* enable PLL1 and wait for lock */ PLLCON |= 1 << 1; while ((PLLLOCK & (1 << 1)) == 0); /* configure MCLK */ CLKCON = (CLKCON & ~(0xFF)) | (0 << 7) | /* MCLK_MASK */ (2 << 5) | /* MCLK_SEL = PLL1 */ (1 << 4) | /* MCLK_DIV_ON */ (div.cdiv - 1); /* MCLK_DIV_VAL */ } void pcm_play_dma_init(void) { /* configure IIS pins */ #ifdef IPOD_NANO2G PCON5 = (PCON5 & ~(0xFFFF0000)) | 0x77720000; PCON6 = (PCON6 & ~(0x0F000000)) | 0x02000000; #else PCON7 = (PCON7 & ~(0x0FFFFF00)) | 0x02222200; #endif /* configure DMA channel */ DMACON0 = (0 << 30) | /* DEVSEL */ (1 << 29) | /* DIR */ (0 << 24) | /* SCHCNT */ (1 << 22) | /* DSIZE */ (0 << 19) | /* BLEN */ (0 << 18) | /* RELOAD */ (0 << 17) | /* HCOMINT */ (1 << 16) | /* WCOMINT */ (0 << 0); /* OFFSET */ /* Enable the DMA IRQ */ INTMSK |= (1 << 10); /* setup PLL */ pcm_dma_set_freq(HW_FREQ_44); /* enable clock to the IIS module */ PWRCON &= ~(1 << 6); /* configure IIS core */ #ifdef IPOD_NANO2G I2STXCON = (1 << 20) | /* undocumented */ (0 << 16) | /* burst length */ (0 << 15) | /* 0 = falling edge */ (0 << 13) | /* 0 = basic I2S format */ (0 << 12) | /* 0 = MSB first */ (0 << 11) | /* 0 = left channel for low polarity */ (3 << 8) | /* MCLK divider */ (0 << 5) | /* 0 = 16-bit */ (2 << 3) | /* bit clock per frame */ (1 << 0); /* channel index */ #else I2STXCON = (DMA_IISOUT_BLEN << 16) | /* burst length */ (0 << 15) | /* 0 = falling edge */ (0 << 13) | /* 0 = basic I2S format */ (0 << 12) | /* 0 = MSB first */ (0 << 11) | /* 0 = left channel for low polarity */ (3 << 8) | /* MCLK divider */ (0 << 5) | /* 0 = 16-bit */ (0 << 3) | /* bit clock per frame */ (1 << 0); /* channel index */ #endif audiohw_preinit(); } void pcm_play_dma_postinit(void) { audiohw_postinit(); } /* set the configured PCM frequency */ void pcm_dma_apply_settings(void) { pcm_dma_set_freq(pcm_fsel); } #ifdef HAVE_PCM_DMA_ADDRESS void * pcm_dma_addr(void *addr) { if (addr != NULL) addr = (void*)((uintptr_t)addr | 0x40000000); return addr; } #endif /**************************************************************************** ** Recording DMA transfer **/ #ifdef HAVE_RECORDING void pcm_rec_lock(void) { } void pcm_rec_unlock(void) { } void pcm_rec_dma_stop(void) { } void pcm_rec_dma_start(void *addr, size_t size) { (void)addr; (void)size; } void pcm_rec_dma_close(void) { } void pcm_rec_dma_init(void) { } const void * pcm_rec_dma_get_peak_buffer(void) { return NULL; } #endif /* HAVE_RECORDING */