/*************************************************************************** * __________ __ ___. * Open \______ \ ____ ____ | | _\_ |__ _______ ___ * Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / * Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < * Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ * \/ \/ \/ \/ \/ * $Id$ * * Copyright (C) 2011 by Amaury Pouly * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version 2 * of the License, or (at your option) any later version. * * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY * KIND, either express or implied. * ****************************************************************************/ #include "audioin-imx233.h" #include "pcm_sampr.h" #include "string.h" /* values in half-dB, one for each setting */ static int audioin_vol[2][4]; /* 0=left, 1=right */ static int audioin_select[2]; /* idem */ void imx233_audioin_preinit(void) { /* Enable AUDIOIN block */ imx233_reset_block(&HW_AUDIOIN_CTRL); /* Set word-length to 16-bit */ BF_SET(AUDIOIN_CTRL, WORD_LENGTH); /* Gate Off */ BF_SET(AUDIOIN_CTRL, CLKGATE); } void imx233_audioin_postinit(void) { } void imx233_audioin_open(void) { /* Gate On */ BF_CLR(AUDIOIN_CTRL, CLKGATE); /* Enable ADC clock */ BF_CLR(AUDIOIN_ANACLKCTRL, CLKGATE); /* Power up ADC (WARNING audioout register) */ BF_CLR(AUDIOOUT_PWRDN, ADC); /* Start ADC */ BF_SET(AUDIOIN_CTRL, RUN); } void imx233_audioin_close(void) { /* Stop ADC (doc says it gate off the module but that's not the case) */ BF_CLR(AUDIOIN_CTRL, RUN); /* Disable ADC clock */ BF_SET(AUDIOIN_ANACLKCTRL, CLKGATE); /* Power down ADC (WARNING audioout register) */ BF_SET(AUDIOOUT_PWRDN, ADC); /* Gate Off */ BF_SET(AUDIOIN_CTRL, CLKGATE); } static void apply_config(void) { int select_l = audioin_select[0]; int select_r = audioin_select[1]; int vol_l = audioin_vol[0][select_l]; int vol_r = audioin_vol[1][select_r]; /* Depending on the input, we have three available volumes to tweak: * - adc volume: -100dB -> -0.5dB in 0.5dB steps * - mux gain: 0dB -> 22.5dB in 1.5dB steps * - mic gain: 0dB -> 40dB in 10dB steps (except for 10) * * This means two available volume ranges: * - line1/line2/hp: -100dB -> 22dB in 0.5dB steps * - microphone: -100dB -> 62dB in 0.5dB steps */ /* First apply mic gain if possible and necessary * Only left volume is relevant with microphone * If gain is > 22dB, use mic gain */ if(select_l == AUDIOIN_SELECT_MICROPHONE && vol_l > 22 * 2) { /* take lowest microphone gain to get back into the -100..22 range * achievable with mux+adc.*/ /* from 52.5 dB and beyond: 40dB gain */ if(vol_l > 52 * 2) { BF_WR_V(AUDIOIN_MICLINE, MIC_GAIN, 40dB); vol_l -= 40 * 2; } /* from 42.5 dB to 52dB: 30dB gain */ else if(vol_l > 42 * 2) { BF_WR_V(AUDIOIN_MICLINE, MIC_GAIN, 30dB); vol_l -= 30 * 2; } /* from 22.5 dB to 42dB: 20dB gain */ else if(vol_l > 22 * 2) { BF_WR_V(AUDIOIN_MICLINE, MIC_GAIN, 20dB); vol_l -= 20 * 2; } /* otherwise 0dB gain */ else BF_WR_V(AUDIOIN_MICLINE, MIC_GAIN, 0dB); } /* max is 22dB */ vol_l = MIN(vol_l, 44); vol_r = MIN(vol_r, 44); /* we use the mux volume to reach the volume or higher with 1.5dB steps * and then we use the ADC to go below 0dB or to obtain 0.5dB accuracy */ int mux_vol_l = MAX(0, (vol_l + 2) / 3); /* 1.5dB = 3 * 0.5dB */ int mux_vol_r = MAX(0, (vol_r + 2) / 3); #if IMX233_SUBTARGET >= 3700 unsigned adc_zcd = BM_AUDIOIN_ADCVOL_EN_ADC_ZCD; #else unsigned adc_zcd = 0; #endif HW_AUDIOIN_ADCVOL = adc_zcd | BF_OR4(AUDIOIN_ADCVOL, SELECT_LEFT(select_l), SELECT_RIGHT(select_r), GAIN_LEFT(mux_vol_l), GAIN_RIGHT(mux_vol_r)); vol_l -= mux_vol_l * 3; /* mux vol is in 1.5dB = 3 * 0.5dB steps */ vol_r -= mux_vol_l * 3; vol_l = MIN(MAX(-200, vol_l), -1); vol_r = MIN(MAX(-200, vol_r), -1); /* unmute, enable zero cross and set volume. * 0xfe is -0.5dB */ HW_AUDIOIN_ADCVOLUME = BF_OR3(AUDIOIN_ADCVOLUME, EN_ZCD(1), VOLUME_LEFT(0xff + vol_l), VOLUME_RIGHT(0xff + vol_r)); } void imx233_audioin_select_mux_input(bool right, int select) { audioin_select[right] = select; apply_config(); } void imx233_audioin_set_vol(bool right, int vol, int select) { audioin_vol[right][select] = vol; apply_config(); } void imx233_audioin_enable_mic(bool enable) { if(enable) { BF_WR_V(AUDIOIN_MICLINE, MIC_RESISTOR, 2KOhm); BF_WR(AUDIOIN_MICLINE, MIC_BIAS, 4); BF_WR(AUDIOIN_MICLINE, MIC_SELECT, 1); } else BF_WR_V(AUDIOIN_MICLINE, MIC_RESISTOR, Off); } void imx233_audioin_set_freq(int fsel) { static struct { int base_mult; int src_hold; int src_int; int src_frac; }dacssr[HW_NUM_FREQ] = { HW_HAVE_8_([HW_FREQ_8] = { 0x1, 0x3, 0x17, 0xe00 } ,) HW_HAVE_11_([HW_FREQ_11] = { 0x1, 0x3, 0x11, 0x37 } ,) HW_HAVE_12_([HW_FREQ_12] = { 0x1, 0x3, 0xf, 0x13ff },) HW_HAVE_16_([HW_FREQ_16] = { 0x1, 0x1, 0x17, 0xe00},) HW_HAVE_22_([HW_FREQ_22] = { 0x1, 0x1, 0x11, 0x37 },) HW_HAVE_24_([HW_FREQ_24] = { 0x1, 0x1, 0xf, 0x13ff },) HW_HAVE_32_([HW_FREQ_32] = { 0x1, 0x0, 0x17, 0xe00},) HW_HAVE_44_([HW_FREQ_44] = { 0x1, 0x0, 0x11, 0x37 },) HW_HAVE_48_([HW_FREQ_48] = { 0x1, 0x0, 0xf, 0x13ff },) HW_HAVE_64_([HW_FREQ_64] = { 0x2, 0x0, 0x17, 0xe00},) HW_HAVE_88_([HW_FREQ_88] = { 0x2, 0x0, 0x11, 0x37 },) HW_HAVE_96_([HW_FREQ_96] = { 0x2, 0x0, 0xf, 0x13ff },) }; HW_AUDIOIN_ADCSRR = BF_OR4(AUDIOIN_ADCSRR, SRC_FRAC(dacssr[fsel].src_frac), SRC_INT(dacssr[fsel].src_int), SRC_HOLD(dacssr[fsel].src_hold), BASEMULT(dacssr[fsel].base_mult)); } struct imx233_audioin_info_t imx233_audioin_get_info(void) { struct imx233_audioin_info_t info; memset(&info, 0, sizeof(info)); /* 6*10^6*basemult/(src_frac*8*(src_hold+1)) in Hz */ info.freq = 60000000 * BF_RD(AUDIOIN_ADCSRR, BASEMULT) / 8 / BF_RD(AUDIOIN_ADCSRR, SRC_FRAC) / (1 + BF_RD(AUDIOIN_ADCSRR, SRC_HOLD)); info.muxselect[0] = BF_RD(AUDIOIN_ADCVOL, SELECT_LEFT); info.muxselect[1] = BF_RD(AUDIOIN_ADCVOL, SELECT_RIGHT); /* convert half-dB to tenth-dB */ info.muxvol[0] = BF_RD(AUDIOIN_ADCVOL, GAIN_LEFT) * 15; info.muxvol[1] = BF_RD(AUDIOIN_ADCVOL, GAIN_RIGHT) * 15; info.muxmute[0] = info.adcmute[1] = BF_RD(AUDIOIN_ADCVOL, MUTE); info.adcvol[0] = MAX((int)BF_RD(AUDIOIN_ADCVOLUME, VOLUME_LEFT) - 0xff, -100) * 5; info.adcvol[1] = MAX((int)BF_RD(AUDIOIN_ADCVOLUME, VOLUME_RIGHT) - 0xff, -100) * 5; info.adcmute[0] = info.adcmute[1] = false; info.micvol[0] = BF_RD(AUDIOIN_MICLINE, MIC_GAIN); if(info.micvol[0] != 0) info.micvol[0] = info.micvol[1] = info.micvol[0] * 100 + 100; info.micmute[0] = info.micmute[1] = false; info.adc = !BF_RD(AUDIOOUT_PWRDN, ADC); info.mic = info.mux = true; return info; }