/*************************************************************************** * __________ __ ___. * Open \______ \ ____ ____ | | _\_ |__ _______ ___ * Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ / * Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < < * Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \ * \/ \/ \/ \/ \/ * $Id$ * * Copyright © 2009 Bertrik Sikken * * This program is free software; you can redistribute it and/or * modify it under the terms of the GNU General Public License * as published by the Free Software Foundation; either version 2 * of the License, or (at your option) any later version. * * This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY * KIND, either express or implied. * ****************************************************************************/ #include #include "config.h" #include "system.h" #include "audio.h" #include "s5l8700.h" #include "panic.h" #include "audiohw.h" #include "pcm.h" #include "pcm_sampr.h" #include "dma-target.h" /* Driver for the IIS/PCM part of the s5l8700 using DMA Notes: - not all possible PCM sample rates are enabled (no support in codec driver) - pcm_play_dma_pause is untested, not sure if implemented the right way - pcm_play_dma_stop is untested, not sure if implemented the right way - pcm_play_dma_get_peak_buffer is not implemented - recording is not implemented */ static void dma_callback(void); static volatile int locked = 0; /* table of recommended PLL/MCLK dividers for mode 256Fs from the datasheet */ static const struct div_entry { int pdiv, mdiv, sdiv, cdiv; } div_table[HW_NUM_FREQ] = { #ifdef IPOD_NANO2G [HW_FREQ_11] = { 2, 41, 5, 4}, [HW_FREQ_22] = { 2, 41, 4, 4}, [HW_FREQ_44] = { 2, 41, 3, 4}, [HW_FREQ_88] = { 2, 41, 2, 4}, #if 0 /* disabled because the codec driver does not support it (yet) */ [HW_FREQ_8 ] = { 2, 12, 3, 9} [HW_FREQ_16] = { 2, 12, 2, 9}, [HW_FREQ_32] = { 2, 12, 1, 9}, [HW_FREQ_12] = { 2, 12, 4, 3}, [HW_FREQ_24] = { 2, 12, 3, 3}, [HW_FREQ_48] = { 2, 12, 2, 3}, [HW_FREQ_96] = { 2, 12, 1, 3}, #endif #else [HW_FREQ_11] = { 26, 189, 3, 8}, [HW_FREQ_22] = { 50, 98, 2, 8}, [HW_FREQ_44] = { 37, 151, 1, 9}, [HW_FREQ_88] = { 50, 98, 1, 4}, #if 0 /* disabled because the codec driver does not support it (yet) */ [HW_FREQ_8 ] = { 28, 192, 3, 12} [HW_FREQ_16] = { 28, 192, 3, 6}, [HW_FREQ_32] = { 28, 192, 2, 6}, [HW_FREQ_12] = { 28, 192, 3, 8}, [HW_FREQ_24] = { 28, 192, 2, 8}, [HW_FREQ_48] = { 28, 192, 2, 4}, [HW_FREQ_96] = { 28, 192, 1, 4}, #endif #endif }; /* Mask the DMA interrupt */ void pcm_play_lock(void) { if (locked++ == 0) { INTMSK &= ~(1 << 10); } } /* Unmask the DMA interrupt if enabled */ void pcm_play_unlock(void) { if (--locked == 0) { INTMSK |= (1 << 10); } } static void play_next(void *addr, size_t size) { /* setup DMA */ dma_setup_channel(DMA_IISOUT_CHANNEL, DMA_IISOUT_SELECT, DMA_MEM_TO_IO, DMA_IISOUT_DSIZE, DMA_IISOUT_BLEN, addr, size / 2, dma_callback); /* DMA channel on */ dma_enable_channel(DMA_IISOUT_CHANNEL); } static void dma_callback(void) { unsigned char *dma_start_addr; size_t dma_size; register pcm_more_callback_type get_more = pcm_callback_for_more; if (get_more) { get_more(&dma_start_addr, &dma_size); if (dma_size == 0) { pcm_play_dma_stop(); pcm_play_dma_stopped_callback(); } else { play_next(dma_start_addr, dma_size); } } } void pcm_play_dma_start(const void *addr, size_t size) { /* S1: DMA channel 0 set */ dma_setup_channel(DMA_IISOUT_CHANNEL, DMA_IISOUT_SELECT, DMA_MEM_TO_IO, DMA_IISOUT_DSIZE, DMA_IISOUT_BLEN, (void *)addr, size / 2, dma_callback); #ifdef IPOD_NANO2G PCON5 = (PCON5 & ~(0xFFFF0000)) | 0x77720000; PCON6 = (PCON6 & ~(0x0F000000)) | 0x02000000; I2STXCON = (0x10 << 16) | /* burst length */ (0 << 15) | /* 0 = falling edge */ (0 << 13) | /* 0 = basic I2S format */ (0 << 12) | /* 0 = MSB first */ (0 << 11) | /* 0 = left channel for low polarity */ (5 << 8) | /* MCLK divider */ (0 << 5) | /* 0 = 16-bit */ (2 << 3) | /* bit clock per frame */ (1 << 0); /* channel index */ #else /* S2: IIS Tx mode set */ I2STXCON = (DMA_IISOUT_BLEN << 16) | /* burst length */ (0 << 15) | /* 0 = falling edge */ (0 << 13) | /* 0 = basic I2S format */ (0 << 12) | /* 0 = MSB first */ (0 << 11) | /* 0 = left channel for low polarity */ (3 << 8) | /* MCLK divider */ (0 << 5) | /* 0 = 16-bit */ (0 << 3) | /* bit clock per frame */ (1 << 0); /* channel index */ #endif /* S3: DMA channel 0 on */ dma_enable_channel(DMA_IISOUT_CHANNEL); /* S4: IIS Tx clock on */ I2SCLKCON = (1 << 0); /* 1 = power on */ /* S5: IIS Tx on */ I2STXCOM = (1 << 3) | /* 1 = transmit mode on */ (1 << 2) | /* 1 = I2S interface enable */ (1 << 1) | /* 1 = DMA request enable */ (0 << 0); /* 0 = LRCK on */ } void pcm_play_dma_stop(void) { /* DMA channel off */ dma_disable_channel(DMA_IISOUT_CHANNEL); /* TODO Some time wait */ /* LRCK half cycle wait */ /* IIS Tx off */ I2STXCOM = (1 << 3) | /* 1 = transmit mode on */ (0 << 2) | /* 1 = I2S interface enable */ (1 << 1) | /* 1 = DMA request enable */ (0 << 0); /* 0 = LRCK on */ } /* pause playback by disabling further DMA requests */ void pcm_play_dma_pause(bool pause) { if (pause) { I2STXCOM &= ~(1 << 1); /* DMA request enable */ } else { I2STXCOM |= (1 << 1); /* DMA request enable */ } } void pcm_play_dma_init(void) { /* configure IIS pins */ #ifdef IPOD_NANO2G PCON5 = (PCON5 & ~(0xFFFF0000)) | 0x22220000; PCON6 = (PCON6 & ~(0x0F000000)) | 0x02000000; #else PCON7 = (PCON7 & ~(0x0FFFFF00)) | 0x02222200; #endif /* enable clock to the IIS module */ PWRCON &= ~(1 << 6); audiohw_preinit(); } void pcm_postinit(void) { audiohw_postinit(); } /* set the configured PCM frequency */ void pcm_dma_apply_settings(void) { // audiohw_set_frequency(pcm_sampr); struct div_entry div = div_table[pcm_fsel]; PLLCON &= ~4; PLLCON &= ~0x10; PLLCON &= 0x3f; PLLCON |= 4; /* configure PLL1 and MCLK for the desired sample rate */ PLL1PMS = (div.pdiv << 16) | (div.mdiv << 8) | (div.sdiv << 0); PLL1LCNT = 7500; /* no idea what to put here */ /* enable PLL1 and wait for lock */ PLLCON |= (1 << 1); while ((PLLLOCK & (1 << 1)) == 0); /* configure MCLK */ CLKCON = (CLKCON & ~(0xFF)) | (0 << 7) | /* MCLK_MASK */ (2 << 5) | /* MCLK_SEL = PLL2 */ (1 << 4) | /* MCLK_DIV_ON */ (div.cdiv - 1); /* MCLK_DIV_VAL */ } size_t pcm_get_bytes_waiting(void) { return DMACTCNT0 * 2; } const void * pcm_play_dma_get_peak_buffer(int *count) { *count = DMACTCNT0 >> 1; return (void *)((DMACADDR0 + 2) & ~3); } #ifdef HAVE_PCM_DMA_ADDRESS void * pcm_dma_addr(void *addr) { if (addr != NULL) addr = UNCACHED_ADDR(addr); return addr; } #endif /**************************************************************************** ** Recording DMA transfer **/ #ifdef HAVE_RECORDING void pcm_rec_lock(void) { } void pcm_rec_unlock(void) { } void pcm_record_more(void *start, size_t size) { (void)start; (void)size; } void pcm_rec_dma_stop(void) { } void pcm_rec_dma_start(void *addr, size_t size) { (void)addr; (void)size; } void pcm_rec_dma_close(void) { } void pcm_rec_dma_init(void) { } const void * pcm_rec_dma_get_peak_buffer(int *count) { (void)count; } #endif /* HAVE_RECORDING */